You probably know this, but when you do the wires/rigging in the mast, a very easy technique to use is to light a candle, take some throw away plastic parts from the model tree, and heat them up a bit.
At a certain point, take it away from the flame, start pulling, and you'll end up with perfect wires.
With a bit of practice, you can even make different diameters of wire by pulling slower or faster and, being plastic, they'll tack right on anywhere with a tiny drop of glue, and are paintable.
Far better than using any type of thread, which doesn't take paint or glue very well, and will deteriorate in time.
At a certain point, take it away from the flame, start pulling, and you'll end up with perfect wires.
With a bit of practice, you can even make different diameters of wire by pulling slower or faster and, being plastic, they'll tack right on anywhere with a tiny drop of glue, and are paintable.
Far better than using any type of thread, which doesn't take paint or glue very well, and will deteriorate in time.
Comment