Luft P/O Badge Opinions Please

[Mike H]

Another case ...

Here is a case for a pilot badge that is similar. As Neil points out, this case will only accommodate a thin version of the badge.

Note this one also has a wood base insert. This would certainly make it easier to have a nice, thin, well-defined hole for the pin to fit in. It also is slightly vaulted around the edges, giving it a particularly nice appearance, to better show off a nice quality badge.

Please don't pry yours apart! Mine came that way --- I would never think about doing that myself. Interior shots below as well.

Mike Heuer

[Mike H]

2.

2.

[Mike H]

3.

3.

[Mike H]

4.

4.

[Mike H]

5.

5.

[Mike H]

6.

6.

[Scott C.]

Thanks for all the good words on this P/O badge & case. I have another P/O badge that I'll try to post this evening for opinions -- I've not seen one like it before and it has given me the jitters the last 17 years I've had it.

Nice pilot badge case case Mike -- ours could have been made by the same manufacturer. I sent you a pm...

[rhudspith]

I have an early Juncker Pilot in a case also same as Mike. I agree with the comment previously that these are specially made for the early thinner badges where the eagle is more vaulted. They will not take the later heavy badge.

Attached photo, Slightly different external finish to Mikes.

Regards
Rob