"Leroy the insignias on the wrapper they are textbook in every way nothing wrong with them if they were loose there would still be nothing wrong."
They look perfectly fine to me, too. All I was saying was that some purists hold that the runes must be totally symmetrical, of exact equal length and equidistant from the sides of the tab, that the piping should be thinner and sewn on with stitches that don't intrude into the visible obverse side of the tab, and that, even with the pip style with mounting prongs as an integral part of the metal, there should be no visible "edge" to the pip showing where the prong is. I personally don't agree with any of this, but I have seen those comments scattered in the hundreds of posts I have read concerning insignia on this forum. I am sure that were these tabs to be posted separately, some of those same comments would emerge from some "expert". Again, I have no personal problem with these insignias AT ALL.
They look perfectly fine to me, too. All I was saying was that some purists hold that the runes must be totally symmetrical, of exact equal length and equidistant from the sides of the tab, that the piping should be thinner and sewn on with stitches that don't intrude into the visible obverse side of the tab, and that, even with the pip style with mounting prongs as an integral part of the metal, there should be no visible "edge" to the pip showing where the prong is. I personally don't agree with any of this, but I have seen those comments scattered in the hundreds of posts I have read concerning insignia on this forum. I am sure that were these tabs to be posted separately, some of those same comments would emerge from some "expert". Again, I have no personal problem with these insignias AT ALL.
Comment