Nice SS-Dagger on E-Stand

[hellracer1]

Hello,

are there any problems with these SS-Dagger marker Hammesfahr on E-stand, I am a little bit confuse from J.R. and Colorados comments.

http://dev.wehrmacht-awards.com/foru...=259688&page=2

Thanks and regards

Winfried

[R_Hessian]

Estand SS blade

Error!

[Colorado]

My first comment is straight forward that started this discussion. The dagger in question appears to have a repainted scabbard and it was not mentioned in the listing.

JR can speak for himself. I note that edges are more sharp in the Hammesfahr example I posted than the dagger in question. Look at the "H" and the double S letter for comparison in "heisst".

[pvluger]

IMO, the scabbard is certainly repainted for this should be an anodized example. The blade is not a ground Rohm for the MM would be much smaller and closer to the crossguard.

My .02

[Stu W]

For info...

I see there is another thread started by the MOD on this blade...

http://dev.wehrmacht-awards.com/foru...d.php?t=259862

Regards,
Stu

[Skyline Drive]

IMO, the scabbard is certainly repainted for this should be an anodized example. The blade is not a ground Rohm for the MM would be much smaller and closer to the crossguard.

My .02

Hammesfahr did not use a smaller trademark for their Rohm's, nor did they place it close to the crossguard.

[pvluger]

Yes, I could be wrong...which ones were they then, was it Boker and Eickhorn that did that? (I dont have TW's book at my disposal)