LUFTSCHUTZ buckle..opinion ?

[Duane E]

[ATTACH]626396[/ATTACH]

[Duane E]

[ATTACH]626404[/ATTACH]

[Duane E]

Sorry duplicate

[Duane E]

Thanks for looking, Duane
Luftshutz7.jpg

[Ric Ferrari]

Hello guys and Happy New Year. Here is a Luftschutz buckle I recently bought. It is stamped steel with a lot of paint on the reverse side. You can see the R.S. but everything else is covered by paint. Any opinions appreciated. Duane

[ATTACH]626393[/ATTACH]

Hallo Duane,

nothing wrong with your SHD buckle, it's 100% original

Best

Ric

[KC1]

Here is my minty GB steel Luftschutz buckle -

Regards - Dan

[KC1]

better view of front - disregard the light

[KC1]

reverse

[KC1]

Wings up close

[KC1]

Gustav Brehmer stamp

[KC1]

Year manufactured stamp

[W.Unland]

Hello,

In looking at these steel "RS&S" buckles I notice that the letters are incised.
The buckle shown here from a dealer's site has raised letters. It also has a strange "washer" on the swivel bar of the belt hooks. Is it a REPRO?

Regards,
W.Unland

[Ric Ferrari]

Hello,

In looking at these steel "RS&S" buckles I notice that the letters are incised.
The buckle shown here from a dealer's site has raised letters. It also has a strange "washer" on the swivel bar of the belt hooks. Is it a REPRO?

Regards,
W.Unland

Hello,

all the original SHD buckles I observed are with raised letters, if you notice them incised probably it's due to the digital picture : btw, the buckle posted is 100 % original.

Best

Ric

[John T]

I think those are cut in letters. Sometimes the photos plays tricks with our eyes.

John

[W.Unland]

I'm sorry, I think I did not ask my question clearly enough, I was refering to the maker's mark. If you look at this comparison, the above examples have incised letters while the one on the dealer's site are raised. Are both acceptable or is the one BO?

Thanks again,
William Unland