Accu, receiver etc
More from the inside!
The accu's which are very very heavy and the receiver.
More from the inside!
The accu's which are very very heavy and the receiver.
-
-
Tower
A nice shot of the Tower. Notice that everything made of copper has to be bend by hand and soldered together. It was a terrible job, but has worked out great!Comment
-
The box
Well, I had this picture taken two years ago....
It's the box the boot came in.Comment
-
Tower
Hee, I found this one also. Its the tower before the paint job. You can see the copper.Comment
-
Box with all parts
This was from the Subcomittee. The box with all parts.Comment
-
More images from the building process
Nice shot from the parts. You can see the pressure hull.Comment
-
And now DIVE!
And this is what it is all about! Dive, dive! (Nup, this isn't my model, I'm almost there...)Comment
-
More Uboot
The last one for now. Same model in the water.Comment
-
Finally the testdive
Well, it took two years to get ready for the testdive....
But anyway I could use the swimmingpool from the childeren, because you never know with a sub, it might sink ;-).
The first picture is the complete RC system, batteries, etc etc. All checked, double checked and checked again (to make sure the double check was ok).Comment
-
Sideview
View from the left side (or right side depends on where you stand).Comment
-
closer look
A closer look at the engineroom.Comment
-
The pressure hull
Lets hope it stays dry...Comment
-
Front canon
Still unused by the crew.Comment
-
Rear canon
Also as new.Comment
-
Type VII-C
Time to put both part together.
Check if the RC equipment still works...
All looks good sofar.Comment
Comment