Hi folks,would this be the right type of buttons for the jacket,they are aprox.25 mm .
They look grey to me and they have some wear to them and vold fit the jacket
good if they are right.
I would also know if there is a good way to clean them a bit.
Also i would like a picture of a jacket were i can see how the buttons are sewed on from the backside.
Thanks in advance.
Thanks Andy because i have a lot of them
Now anyone have a tip on how to clean them a bit and does anyone have a picture of the back side of a button (back side of the jacket were it's sewed on)
Is there some kind of "plate" there as a reinforcement.
Regards.
Hi Frank,don't quite follow you here.
The buttons are 25 mm around(diameter) are you talkin about thicness?
Please tell me if i've misunderstood or not.
Best regards.
And soldier's will apart, that used lots of type of buttons, IMHO you needs the metallic grey ones... The same kind I've always found on untouched garment!
Comment