mas36 bayonet used on a smg fg42

[HENRY BUCKI]

could someone tell me the overall length of a mas36 bayonet used on a smg fg42 2ad model. ater cutting the tip ,thanks

[Leper]

Why don't you wait until you get yours then cut it to fit. Or send it to rick and pray that it comes back with the rifle. Then raise an intereeb stink because it does not.

[HENRY BUCKI]

its sort of like when you are waiting on a full auto. from atf you buy mags ,ammo while waiting makes the wait go by faster.

[Leper]

This is why I no love ne'er get on 'lists'

[Leper]

Seriously I did not type half of that last post.

[gurtsack]

hello, on the FG42 it is a very similary CR39 bajonet not MAS 36

[HENRY BUCKI]

http://smgguns.com/?page_id=1389

[pitfighter]

hello, on the FG42 it is a very similary CR39 bajonet not MAS 36

It is almost identical to a shortened MAS36 bayonet - which will fit perfectly.
The GCY (Dietriech) factory marked originals are virtually the same - except the end cap seal.

Henry - mine is on an original Krieghoff, I can measure my cut down MAS or the Estes Adams reproduction - but is yours going on an original rifle or on one of the Texan SMG semi-autos? - I am not sure if there is a difference as I do not own an SMG gun.

[HENRY BUCKI]

it will be on a smg fg42.

[Sgt. Steiner]

Has SMG put the FG-42 Type 1 in production?

[R_Hessian]

Ok

I'll do that for you.

[R_Hessian]

!

11 1/16 inches.

[HENRY BUCKI]

11 1/6 is the blade length? the point to edge of base that houses locking mech correct? any idea on measurement from one end to other end? thanks for your reply

[R_Hessian]

From end to end, the total length of the bayonet.

[HENRY BUCKI]

thanks alot