Looking for MG34 barrel shroud spare parts

[madmodder123]

Hi, i'm looking for an extra plunger + push button for the MG34 barrel shroud
ezv5.jpg
A25 and A27

PM me if you want to sell them. Thanks

[feind-hort-mit]

Just for your information,
the plunger and nut underneath are not screwed together, in order to make sure they don't come apart they are hollow riveted / peaned over.
In order to part them you have to drill the underside end, unfortunately by doing this it will make it shorter and therefore not long enough to push up far enough.
Good luck.

[me6_130]

Just for your information,
the plunger and nut underneath are not screwed together, in order to make sure they don't come apart they are hollow riveted / peaned over.
In order to part them you have to drill the underside end, unfortunately by doing this it will make it shorter and therefore not long enough to push up far enough.
Good luck.

Not totally exact. It is true they are hollow riveted but can be taken apart by hammering through with a pin remover, so you can later mount it back. I have done such an operation. If you don't do it well, it might be a bit lose later...

Carles