Can anyone tell me how to disassemble the FLaPivot15? Need to take it apart for restoration. Thanks for any help
-
-
sucess - Figured it out
I found a pin on the back side of the swivel part of the mount body which runs parallel to the horizontal plane. It was covered in rust and not real visible. Take that pin out (knocking it from the left side as you would stand behind the gun if mounted) and the swivel assembly the gun mounts on, will come off. Also will show the screw assembly that tightens the leg to the stump.
Appears you tighten the leg assembly to the stump using a spanner wrench to turn the flat sided head of the screw which applies pressure to the legs, drawing them in around the stump. Once that tight then place the swivel assembly with gun mount on top of the leg assembly, put the pin in and you are done.
Comment