Hermann Meyer cap hilfe

[Lloyd I.]

Im either going to end up with one of these or look like this . opinions please. Kokarde had pin reattached no bigee to me as they are all over the place. All comments welcome. I'll provide the best I can. Makers Mark is very hard to read. Carl Berger or something......

[Lloyd I.]

2

[Lloyd I.]

3

[Lloyd I.]

4

[Lloyd I.]

Interior has added cloth sweatshield and cap buttons marked fien hand sewn on sides. Thread test passed.

[Lloyd I.]

Faint makers mark. Anyone know? This was the best I could do indoors.

[Lloyd I.]

vent grommets

[B. N. Singer]

Im either going to end up with one of these or look like this . opinions please. All comments welcome. I'll provide the best I can.

From those pictures, I could entertain a doubt.

B. N. Singer

[Mike Dalton]

Well, from what I can see, the cap itself holds some promise. I do like the interior(again,from what I can see). Obviously the insignia is incorrect for the special insignia mandated for this cap. The vent hole screens have me a bit concerned. Reminds me of what ya got at the faucet of your kitchen sink. Just my observations and I'm sure we will hear more.

[John Hodgin]

I see nothing, not one single detail, to assure me the cap is in any way authentic and would advise passing on it. IMHO the cap has the metal insignia because the repro Bevo insignia that was originally intended for it would be a glaring give away of it being a reproduction. Then there is the metal insignia; thumbs down.

John

[Lloyd I.]

Thank you. I passed. Too bad it wasnt legit.