unihook, and pin hinge BWB....maker? who knows ??

[juoneen]

[juoneen]

[juoneen]

[juoneen]

Check out the three balls in the left center of the left sword hilt, and two on the right.

[juoneen]

sure is an ugly sucker, but likely saved manufacturing costs being a uni- badge

[Ninja]

A lot of makers used this design.
Here is 16, 81, 107, 63, 110, 39 and 91.

Not my picture, fund it on WAF can’t remember the post.

Rasmus

[rbminis]

Also "65".

[Ronny.R]

A lot of makers used this design.
Here is 16, 81, 107, 63, 110, 39 and 91.

Not my picture, fund it on WAF can’t remember the post.

Rasmus

Top left is 67 I know as the picture was posted by me

Also maker 58, 95 and 71 used this setup

Cheers,
Ronny

[Chrvip68]

This maker has the standard 'ghost' design with the unique thin mat finish, haven't figured out the maker yet, perhaps WB guru Ronny or Andreas can shed some light...