anyone have or seen one of these pins on a minesweeper or other badge. If so can you post a pix? It has an all brass appearance and the swelling is very near the bottom. I usually only see the swelling near the top or in the middle. thanks.
-
-
Hello Tony,
This pin is quite typical on badges made by Förster & Barth. Sometimes you will find their LDO code 'L/21' marked on the pin in incuse relief. The badge looks original.
Best regards! TomMihi libertas necessest! -
Looks fine so far. Do a search on the forum and you should see a few more
Comment
Comment