Pab Wurster Silver

[PODO01]

****

added some additional pics.hope these help.

thanks tom

[PODO01]

****

Got Some Measurements:

Width: 41mm
Height: 61mm

[Don D.]

Can you show us some side views of the catch?

[hagwalther]

Those marks to the rear bottom left - could these be the broken air bubbles from a casting?

Regards ...

[PODO01]

****

More Pics 1

[Chet Sowersby]

Tom,
Thanks for the close up shots. Besides a good close up of the hinge I would like to see a dead on view of the pin where it bends around the hinge taken from above. Sorry to be such a pain asking for more pictures. The pitting, hinge/pin, and color does not set well with me. Lastly, where did you obtain this badge?

Chet

[PODO01]

****

More Pic 2

[Don D.]

Reminds me of the old pillow crimp/s&l fake. Same metal etc...

[Jeff V]

Hi Tom, I don't like this one, and I would return it. There are plenty of badges without the problems this one has. best wishes,
jeff

[Chet Sowersby]

I'am with Jeff on this one, "return to sender"

Chet

[Indy]

hi Tom

I just checked my Wurster PABs. I'm sorry that this is a bad one. Yours look like a "lead" PAB not zinc PAB. The hinge is not good, and check the red circle... you can see two gooves on reverse if you find a good one. Hope you can get your money back.

Kr
Indy

[Christopher G.]

I have to agree with everyone here.....I have seen this post from the very beginning just to see how it progressed and I still have the same feeling as before "I dont like it". I pitting/air bubbles was a first indicator for me as well as just about everyone else. Also to me the finish looks quite odd....but thats just me.

KR
Chris G.