Hí guys
I want to show this the new my type.
this the type not simple find
What do you think about it ?
I want to show this the new my type.
this the type not simple find
What do you think about it ?
-
-
the back
&
I have had such pieces to me, but now I found an almost perfect condition -
So many years I collect crosses EK2-1939, and here in a short period of time I see 2 crosses P&L "new type". Interesting ...
Sanya, if big ring in your cross is also thin and large diameter?
Regards
JarekComment
-
Hí Jarek
I'm now not at home , but when arrived at home i will see and answer to you
but I think if I remember correctly the my on old piece was a little size ring
I will seeComment
-
Yes Jarek .... P&L with the small ring .
DouglasComment
-
O.K. Thanks - I dropped the weight of the heart
Regards
JarekComment
-
on the medalbar yet I can't watch ,but here is the another my piece
the ring
tomorrow will watchComment
-
Sanyas just posted cross has a mid size ring ... 3 sizes .
DouglasComment
-
Why the attention to the ribbon ring?
These are quite common on medal bars and I m pretty sure whoever made the bar adjusted the ring if needed. This is common if you check various medal barsComment
-
It is just noted that in Post 3 by Jarek - happens to have an Imperial resembling size ribbon ring .
A thickness and size only used by a few other makers . That large ring would have been cut off - if it had been mounted on a TR medal bar .
Not sure if that could go as is on an Imperial medal bar ?
DouglasComment
-
Hí guys unfortunately the medalbar I can't precisely measured ,because very
taut the ribbon and I do not want that the ribbon be wrong
so only on the through ribbon can measure,the size was 11,21 mm
(possible 3 size the ribbon thickness )
but the my another piece size is : 10,12 mmComment
-
In my opinion there is only one type of ribbons ring in crosses EK2-1939 by Petz & Lorenz.
In all the crosses P&L that I had in my hands (5 pieces) ring diameter was in the range: 9.93 - 11.05 mm (I think that's the difference in the margin of error production).
Given Sanya's measurements, I think we can assume that the correct diameter of the ring in the crosses EK2-1939 P&L should be within the limits: 9,9-11,2mm.
In my opinion, the "picture" awards in Catalogues are only illustrative, and do not always have anything to do with the actual dimensions of the decorations sold.
But I stress, it's just my opinion.
Regards
JarekComment
-
There is nothing wrong here Jarek .
There is 1 type TR ribbon ring - compared to other makers - on the small side .
DouglasComment
-
-
in my opinion this the ribbon ring not the normal size,but
this the type a early made type,and possible that this the piece so made or someone changed over the years,
but this nothing to lose value,this is a incredible in condition piece I never saw such ago
and known that this the type made of zink ,and incredible pieceComment
Comment