BAR magazine dimensions needed

[Tino]

I like to fill my BAR belt with some magazine props.
Can anyone give me the dimensions for these clips so I can make some props to fill my pouches?

Thanks in advance,
Tino

[captainhoot]

Tino.
The dimensions are: 14.5 cm at the long end. 12.5 cm short end. 9.0cm wide, 2.5 cm thick. Realize that the mag is angled, being shorter in the front, as it sits in the weapon.
Hope this helps.
Also, this is called a magazine, not a "clip". Sorry, just a pet peeve of mine...

-Andrew

[Tino]

Thanks Andrew

[ramon]

...
Also, this is called a magazine, not a "clip". Sorry, just a pet peeve of mine...

-Andrew

Bravo!! Thank you

[Gary Cain]

Actually Andrew, If we're going to be persinickety here they are properly called a "box magazine"


Gary

Tino.
The dimensions are: 14.5 cm at the long end. 12.5 cm short end. 9.0cm wide, 2.5 cm thick. Realize that the mag is angled, being shorter in the front, as it sits in the weapon.
Hope this helps.
Also, this is called a magazine, not a "clip". Sorry, just a pet peeve of mine...

-Andrew

[ramon]

persnickity is good....