Announcement

**The Jackal** · 05-14-2016, 05:22 PM

Hmmm... I took something action. Is this sufficient enough? A 4 step tutorial. Step 1. Cutting the torso down to a smaller size.

Verstuurd vanaf mijn SM-G935F met Tapatalk

**The Jackal** · 05-14-2016, 05:23 PM

Step 2; applying a plastic barrier and holding it in place with tape.

Verstuurd vanaf mijn SM-G935F met Tapatalk

**The Jackal** · 05-14-2016, 05:24 PM

Step 3; putting the cotton layers (with one 100% cotton T-shirt as top layer) on.

Verstuurd vanaf mijn SM-G935F met Tapatalk

**The Jackal** · 05-14-2016, 05:25 PM

Step 4; putting the tunic back on the the torso.

Verstuurd vanaf mijn SM-G935F met Tapatalk

**The Jackal** · 05-14-2016, 05:26 PM

What do you think. Good enough?

Verstuurd vanaf mijn SM-G935F met Tapatalk

**The Jackal** · 05-15-2016, 04:36 AM

Or is replacing for a plastic one as showed in the picture below the best solution?

Verstuurd vanaf mijn SM-G935F met Tapatalk

**The Jackal** · 05-22-2016, 10:01 AM

Just did another. Had to make it a lot smaller to fit a new tunic that just came in. Foam al over the place[emoji16] , but the job is done 😃.

Regards,

Jac

Styrofoam Display Torsos.