Deumer Spange combo - a dual clamshell screwback piece

[all1knew]

Hello all,

Just picked up this lot and wanted to share with everyone. Pretty sure the Spange is a rarity of some sort. Has anyone ever even seen an authentic dual clamshell setup like this before?

William Kramer

[all1knew]

2

[all1knew]

3

[CMSgt]

dual

That is a beautiful spange set and the first one I have seen. The two second class spanges look like S&L. Jim

[sanya13]

I like it this the spange

[StefanK.]

very intersting and nice! Looks factory-made for me.

greetings, Stefan

[ben bijker]

very intersting and nice! Looks factory-made for me.

greetings, Stefan

+ 1...
Never seen anything like it before, but I like it !

[Gew44]

+1
nice

[tinmantis]

again, never seen anything like that, surely special order
as a Deumer spange lover, that's truly a total mindblower!
Never thought I'd see anything so nuts and legit
regards
jon

[Disco Partisan]

Are you sure "factory-made"? Maybe soldered to each other by request of the owner when purchased as two awards (?)

[CMSgt]

set

Are you sure "factory-made"? Maybe soldered to each other by request of the owner when purchased as two awards (?)

The screw on the EKI is too low for the two to have been mated. Normally the screw is in the center. Jim

[Tony T-S]

Yes, and it doesn't look to have started life in any other position so looks factory made.

[TRAVLRSEASIA]

Deumer Combi

The screw on the EKI is too low for the two to have been mated. Normally the screw is in the center. Jim

I completely agree..factory made without question! A true rarity!

[Jean-Claude]

Wow! A first for me too... It looks as if there is enough of a gap between the 2 screw disks that this set up would have worked well even if the 2 screws had been centered in the EK & the spange as you normally see on factory screwbacks and just solder them together to make the combo. The EK 1 with the offset screw denotes this is really something special/custom.

Congratulations William for this really nice find!

JC

[Disco Partisan]

The screw on the EKI is too low for the two to have been mated. Normally the screw is in the center. Jim

yes of course I just did not look there..
All1knew
wow what a find! A Dream! Where did find it man?