Prague bar

[TerryG]

Saw this on the last Detlev update (photo taken from Detelev's site.

[TerryG]

Prague bar

.....but I always thought that this type of rear prongs was the one to go for. Any comment on this from anyone??

[rhudspith]

Hi Terry,

Can't comment on this other than that I was going to try and buy it until I saw the pins. I prefer the accepted version that you show.

Regards
Rob

[J Temple-West]

Both are correct.. copies of the bar tend to be smaller than originals..

[Christian L]

could someone post the dimensions of known originals and known fakes please.
thanks much christian

[TerryG]

could someone post the dimensions of known originals and known fakes please.
thanks much christian

Mine is 3.15 x 1.15 cm. I no longer own the one in the photo however, but these measurements are taken from this one which has the same triangular prongs.

[kev105]

Yes, mine has triangular prongs and has the same measurements (3.15 x 1.15cm)

Kevin

Mine is 3.15 x 1.15 cm. I no longer own the one in the photo however, but these measurements are taken from this one which has the same triangular prongs.

[Don D.]

here it is

This finally arrived. Measurements are: 30.5mm X 10.5mm wt is 2.6 grams.

[Don D.]

the back.

[Don D.]

marked .40 marks